Cody Kent

Whether it’s an hour late or a day late, delayed shipments can cost a jobsite precious time and money. That’s why you need a fastener supplier with a fast and reliable delivery system – Allfasteners is that supplier.

From onsite services to tool calibration, Allfasteners can provide more than just fasteners for the job – in fact our range of services may be the missing link you need to complete the job.

As the race to 5G continues, everyone seems to understand the benefits of 5G and its potential to change the way we interact with the world. From telemedicine to more efficient and faster-moving cities, the benefits of 5G are simply amazing, but how will all of this come to fruition?

One of the leading causes of injury on the jobsite is falling – especially from heights. To address this issue, OSHA set forth new regulations surrounding fixed ladders extending over 24 feet.

Two of the most commonly confused sets of regulations are those of the Buy America and the Buy American Acts. Even their names are almost identical. But, mistaking one requirement for the other can result in contract termination, suspension, and much more – that’s why it’s important to understand the differences.

Allfasteners isn’t new to making and sourcing products from the United States, we’ve actually been doing it for decades. These years of hands-on experience have given us helpful knowledge of compliances and regulations – and has gained us access to some amazing jobsites!

For many years, the tower industry has been tasked with the challenge of installing and removing loose bolts, straps and buckets at heights – when reached – are found damaged or missing, leaving the concealment panels susceptible to blowing open or even coming off the pole. 

In a recent interview with one of our New Jersey representatives – Matthew Walker – we discussed his work on the famous Woolworth Building in New York City.

A jobsite in Garden City contacted one of our representatives about a building requiring HVAC and fire protection installation anchors to be pull tested, we were happy to assist.

AF35LVE is a two-component, low viscosity epoxy designed for deep embedment of anchor rods in large diameter holes due to its zero shrinkage and longer working times. AF35LVE has a thixotropic gel-like consistency, and it flows when under pressure and gels once injection stops.